Thermal Bridges.

Everything concerning hygrothermal Sources & Sinks within the assembly
Post Reply
yalinu
WUFI User
WUFI User
Posts: 8
Joined: Fri Jul 11, 2008 10:35 am -1100
Location: New York
Contact:

Thermal Bridges.

Post by yalinu »

I am a new member of the forum and would like to say hello to everyone here.

I am working on a building assembly that has some thermal bridges.

Is there an approximate way to simulate a thermal bridge in WUFI using heat sources and sinks?

Finally, what would be the best location to place the heat source/sink. For example: in the center of the layer, or close to a layer surface.

I would greatly appreciate advice from anyone that has gone through a procedure or process to simulate a thermal bridge in WUFI 4.

Best,

Yalin
Manfred Kehrer
WUFI International Support Team
WUFI International Support Team
Posts: 351
Joined: Thu Mar 10, 2005 2:17 am -1100
Location: Northbrook, IL; USA
Contact:

Post by Manfred Kehrer »

Dear Yalin,

I think it is not the right way to simulate thermal bridges using sources and sinks.

The best position of the source/sink depends on your specific problem.

Best Regrads,

Manfred
Manfred
Wiss, Janney, Elstner Associates, Inc.
Official WUFI® Collaboration Partner for USA/Canada
Enjoy WUFI® :) .... It is easy and complex.
yalinu
WUFI User
WUFI User
Posts: 8
Joined: Fri Jul 11, 2008 10:35 am -1100
Location: New York
Contact:

Post by yalinu »

Thanks Manfred. Just wanted to know if there were any precedents for it.
Post Reply