Initial conditions form file in WUFI 2D

[Teresa Stingl]

Hello,

I needed help with WUFI 2D on two issues:

1) How can I enter, as the initial conditions of a construction element (made up of various materials), the final T and RH profile of a previous simulation? Should I remove these profiles from wufiGraph or from WUFI2D motion?

2) I read that it was possible to extract the T and RH conditions used as boundary conditions (input) from the Wufigraph results file (just to check). To do this, I thought I had to select a point on the grid corresponding to that boundary condition (usually shown in blue) and ask for the graph. It turns out that when I do this I get a T and RH equal to zero (?).

Thanks in advance,

Teresa Stingl Freitas