WUFI

Thank you very much Christian. The modification of the NSW parameter was what allowed the results obtained in 2D simulation to be adjusted with those obtained with the simulation 1D. Next I will try to perform the 2D simulation of the complete detail and carry out the simulations campaign with diffe...

Dear AMG, from the submitted images, it is not clear why the results do not match. Have you checked all materials, transfer coefficients and boundary conditions to see if they are identical? further the balances in WUFI Pro should match as well as the timesteps in in WUFI 2D should converge. THe ev...

Dear AMG, for comparing WUFI Pro with 2D results, you have to use the same grid in both programs and the same convergence criterion, WUFI Pro uses 1e-6. Christian Dear Christian, Thanks for your reply. I modified the convergence criterion to 1e-6 and on the other hand, the mesh I had was the same i...

Dear colleagues I have been doing a simulation campaign with different internal insulations using Wufi 1d and Wufi 2d and I have a problem in the cases of most unfavorable scenarios (when using an internal vapor barrier and not protecting the outer face by a rain repellent application). I obtain a b...

Hello! Following the thread of this topic, I was interested in the evaluation of the wood rot. I´m sorry if it was better to open a new topic in the new section of "Post-Processing Modules" due to the future post-processor dedicated to wood rot that is under development as indicated in the...