Search found 4 matches

by burketthw
Thu Apr 23, 2015 5:29 am -1100
Forum: General
Topic: Isolate 1D Heat/moisture transfer in WUFI Plus, or use WUFI 5.3?
Replies: 4
Views: 13343

Re: Isolate 1D Heat/moisture transfer in WUFI Plus, or use WUFI 5.3?

Is it possible take a complete file created in WUFI plus, and import the wall assembly information into WUFI Pro?, to run a 1D analysis on the wall assembly by itself?
by burketthw
Wed Feb 11, 2015 6:58 am -1100
Forum: General
Topic: Isolate 1D Heat/moisture transfer in WUFI Plus, or use WUFI 5.3?
Replies: 4
Views: 13343

Isolate 1D Heat/moisture transfer in WUFI Plus, or use WUFI 5.3?

Hi, I need to analyze the one-dimensional thermal and moisture transfer through a wall assembly using recorded internal and external Temp and RH. I have an educational license of WUFI Plus and a trial version of WUFI ORNL 5.3. Using WUFI Plus, is it possible to isolate one wall assembly, and import ...
by burketthw
Fri Oct 24, 2014 2:50 am -1100
Forum: WUFI Plus
Topic: Assembly configuration questions
Replies: 1
Views: 4787

Assembly configuration questions

I have been using WUFI Plus 2.5.3.0 to model the energy use and heat/moisture transfer in very small residential buildings. I have a few questions that I could not find an answer to on the wiki or the forum or in the manual. 1. I need to know how the software model the connections between walls, cei...
by burketthw
Wed Jun 11, 2014 5:04 am -1100
Forum: WUFI Plus
Topic: defining assembly for components of attached zones?
Replies: 1
Views: 4549

defining assembly for components of attached zones?

I am modeling a small, single zone structure that has a ceiling and an unconditioned and unvented attic (the thermal barrier is at the ceiling). After using the building wizard, a model was created, identifying the attic as an attached zone. This seems accurate since it is unconditioned, but there i...