Hello,
I am a new user of Wufi, and I am currently struggling to adjust my isoline graphs after the Wufi2D study.
In link of this post, you can find 2 images (structure.png which represents the normal form of my structure, and isoligne.png for the final form of the temperature isoline graph (all the isolne graphs have the same aspect)).
I would like to have the isoline graph fitting the structure form, and not a "streched" version of it. Is there any parameters to address this issue? I have tried every paramaters in the options but non of them works.
Thank you in advance for any help you can give me!
Best regards,
HENIN Valentin
Isoline graphs parameters
-
HENIN Valentin
- WUFI User
- Posts: 1
- Joined: Sat Jul 04, 2020 4:07 am -1100
Isoline graphs parameters
- Attachments
-
- structure.png (12.35 KiB) Viewed 6229 times
-
- isoligne.png (186.28 KiB) Viewed 6229 times
Re: Isoline graphs parameters
Hello,
perhaps you should install and try VisIt.
To enable VisIt in WUFI2D just supply the correct path in WUFI2D (WUFI2D->options->settings->application->VisIt post processor) - this will add a button/shortcut to start VisIt and load your result file.
Happy post processing
Veit
perhaps you should install and try VisIt.
To enable VisIt in WUFI2D just supply the correct path in WUFI2D (WUFI2D->options->settings->application->VisIt post processor) - this will add a button/shortcut to start VisIt and load your result file.
Happy post processing
Veit