Page 1 of 1
Problem with vertical subdivisions in WUFI Passive Manual Example
Posted: Tue Jul 21, 2015 12:38 pm -1100
by russ@goodshacks
I'm working through the Example Case in the WUFI Passive 3.0 Manual. When I get to the vertical subdivision of a layer to use for exchange material (page 146) I find that I cannot create subdivisions that match the example. When I enter the vertical subdivisions of .04 and .36 meters the vertical total should adjust to .40 meters, but it stays at 1 meter and creates a third subdivision of .60 meters that I can't delete. Any help would be appreciated.
Thanks,
-Russ
Re: Problem with vertical subdivisions in WUFI Passive Manual Example
Posted: Thu Jul 23, 2015 9:08 pm -1100
by mpazold
Hi Russ,
make sure that no other layer has vertical subdivision entries. The vertical and horizontal subdivisions are allways regarded from the layer with the biggest sum for the entire assembly.
So i think you have entered 1 meter in another layer vertical subdivision, then the remaining .6 meters are added automatically.
hope this helps, Matthias
Re: Problem with vertical subdivisions in WUFI Passive Manual Example
Posted: Wed Aug 05, 2015 6:03 am -1100
by russ@goodshacks
Thank you. Your suggestion worked. Much appreciated.