IP SI Units Conversion Problem
Posted: Tue May 07, 2019 5:00 am -1100
Version 6.3.2 noted some fixing of unit conversions. There is still a problem. If I set WUFI units to IP and then import from the library, I can have bad rounding errors that damage materials. If I import library materials in SI and then change to IP the results are OK. Try this with North America Polyisocynurate Board. When set to IP units at import, there is a back step in the sorption isotherm curve that prevents the simulation run. That dos not occur if the material is imported while in SI units and then converted to IP.