How to change layer thickness and change climate
Posted: Tue May 18, 2010 2:53 am -1100
I prepared a new geometry in Wufi2d (Geometry) with the available drawing tool.
A) In the next step, I went to the window "Grid".
I got a red line " layer #8 has thickness zero".
What does it mean and can I go on?
B) I went to the window Surface/Climate.
The geometry is shown there and it is possible to assign a climate to most of the external faces of the geometry. However, a few external faces are not accessible and remain black. They are not included in the table of the various faces below the geometry.
How to activate them?
Thank you
Thank you
A) In the next step, I went to the window "Grid".
I got a red line " layer #8 has thickness zero".
What does it mean and can I go on?
B) I went to the window Surface/Climate.
The geometry is shown there and it is possible to assign a climate to most of the external faces of the geometry. However, a few external faces are not accessible and remain black. They are not included in the table of the various faces below the geometry.
How to activate them?
Thank you
Thank you