Page 1 of 1
output an initial condition-or-continue last calculation
Posted: Fri Nov 08, 2019 1:41 am -1100
by yuan
I was calculating hygrothmeral behavior of the ground, and it needs a long time to heat up. So I was wondering is it possible to output the temperature distribution results at the final stage, and then input it as an initial calculation in a new calculation?
Thank you so much!
Re: output an initial condition-or-continue last calculation
Posted: Mon Nov 11, 2019 2:16 am -1100
by Christian Bludau
Hi Yuan,
yes, thats possible.
Open the results in WUFI 2D Motion, press backspace to get to the last time step of your calculation or use Ctrl + G to go to the step to export.
Do a right-click on temperature and select extract -> initial conditions. Do that as well for the water content or relative humidity.
In WUFI 2D go to "Initial Conditions" -> "Use initial conditions from file" to import these files.
Christian
Re: output an initial condition-or-continue last calculation
Posted: Tue Nov 12, 2019 1:15 am -1100
by yuan
Thank you so much dear Bludau!!! that helps me a lot!
Yuan