Limiting Isopleths Lines

bek15212 · Post by **bek15212** » Tue Mar 01, 2011 7:34 am -1100

Is there anyway to get the limiting isopleths lines LIM B1 and LIM B II in any of the other monitoring position graphs? I only see them on the interior surface graph. It would be a good to have them on the interior side of the drywall, where there is paper, i.e. food for fungal growth.

Christian Bludau · Tue Mar 01, 2011 8:03 pm -1100

We took out this lines on purpose for the LIMs, because they were determined for the conditions on the inner surface. But if you think you have a material in the inside, which is a good substrate for growth, you can also use the model. At the moment you only can extract the temperature and moisture data and combine it manually with the isopleths. In the program itself it is not possible, but in a view days there will be a new post process module available for Wufi which is able to analyze the growth conditions at every position. Just check our website next week. The post process should be called "Wufi Bio".

bek15212 · Post by **bek15212** » Wed Mar 02, 2011 6:00 am -1100

I think I have the WUFI Bio with the package of items I received at the Advanced Seminar. I've used it but am not sure I can isolate each layer but I will check. Thanks.

Christian Bludau · Wed Mar 02, 2011 6:08 am -1100

Since today there is the new version of Wufi-Bio online. http://www.wufi.de/wufi/downloads_e.html#wufibio
Install it, then calculate your construction, got to the Wufi-Film and you will find a new symbol. Clicking that, you can choose any grid element to do a Wufi-Bio-analysis.
Hope that helps,
Christian

bek15212 · Post by **bek15212** » Wed Mar 02, 2011 6:12 am -1100

Christian,

This new installation will work with my 8 week license copy, i.e. I will not loose the remaining time I have to play with and understand this software?

Christian Bludau · Wed Mar 02, 2011 6:17 am -1100

No, that should work... If not, contact me....

bek15212 · Post by **bek15212** » Wed Mar 02, 2011 6:23 am -1100

Thanks