HDF5-DIAG : Error detected in HDF5 (1.8.17) thread 0

All about WUFI 2D
Post Reply
eunseop ahn
WUFI User
WUFI User
Posts: 2
Joined: Wed Aug 19, 2020 10:03 pm -1100

HDF5-DIAG : Error detected in HDF5 (1.8.17) thread 0

Post by eunseop ahn »

Hello!
I am a beginner of WUFI 2D 4.3.
I am trying to simulate a steel structure modular house junction.
I modeled as below, and I haven't put in the source yet.
An error occurred in the calculation result, and the result is unknown.
What is the cause of the error?
*.wfd simulation result file was not created.

** Questions
1) What is the cause of the error?
2) Is there a size limit for modeling supported by the WUFI 2D?
3) Is it possible to model a 1mm thick steel structure?

Best Regards,
Ahn
Attachments
b5.jpg
b5.jpg (489.41 KiB) Viewed 5619 times
b1.jpg
b1.jpg (152.07 KiB) Viewed 5619 times
test-3.zip
(823.78 KiB) Downloaded 349 times
Christian Bludau
WUFI SupportTeam IBP
WUFI SupportTeam IBP
Posts: 1160
Joined: Tue Jul 04, 2006 10:08 pm -1100
Location: IBP Holzkirchen, the home of WUFI
Contact:

Re: HDF5-DIAG : Error detected in HDF5 (1.8.17) thread 0

Post by Christian Bludau »

Hi eunseop ahn,

your construction is to big for the grid setting, so the grid can not be fully build. There is a little red error message in your grid window, you should not ignore. Please try to increase the maximum grid elements from 150 to 300.
Further you build a detail with a very high grade of details. You should think about simplifying your construction.

Christian
eunseop ahn
WUFI User
WUFI User
Posts: 2
Joined: Wed Aug 19, 2020 10:03 pm -1100

Re: HDF5-DIAG : Error detected in HDF5 (1.8.17) thread 0

Post by eunseop ahn »

Hi, Christian Bludau!
Thank you so much for the very quick answer.
I will try again as you taught me.
This WUFI-forum is really helpful, and thanks again to Christian for kindly responding to all the articles.

Best Regards,
Eunseop Ahn
Alberto Morales
WUFI User
WUFI User
Posts: 60
Joined: Tue Mar 29, 2022 10:57 pm -1100

Re: HDF5-DIAG : Error detected in HDF5 (1.8.17) thread 0

Post by Alberto Morales »

hi eunseop ahn,

how did you define the hygrothemal properties/functions of the steel studs?

thanks in advance
Post Reply